REAR POWER WINDOW SWITCH INSPECTION

PROCEDURE


  1. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY


    1. A001E5UE10
      *1 Component without harness connected: (Power Window Regulator Switch)
      *2 UP
      *3 DOWN

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      2 (UP) - 5 (GND) Manual UP operation Below 1 Ω
      10 (DOWN) - 5 (GND) Manual DOWN operation Below 1 Ω
      4 (AUTO) - 5 (GND) AUTO UP / DOWN operation Below 1 Ω

      • If the result is not as specified, replace the rear power window regulator switch assembly.

    2. Check that the LED illuminates.

    3. Apply battery voltage to the power window regulator switch and check that the LED illuminates.

      OK:
      Measurement Condition Specified Condition

      Battery positive (+) → 8 (LED)

      Battery negative (-) → 5 (GND)

      		 LED illuminates

      • If the result is not as specified, replace the rear power window regulator switch assembly.