POWER WINDOW CONTROL SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use these procedures to troubleshoot the power window control system.

  • *: Use the intelligent tester.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT BATTERY VOLTAGE

    Standard voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding.

    Result
    Proceed to
    NEXT

    NEXT

  3. CHECK FOR DTC (ELECTRIC POWER CONTROL SYSTEM)*


    1. Using the intelligent tester, check if the electric power control system is functioning normally.

      Result
      Result Proceed to
      DTC B22B3 is not output A
      DTC B22B3 is output B

    B

    GO TO ELECTRIC POWER CONTROL SYSTEM Click here

    A

  4. CHECK FOR DTC*


    1. Check for DTCs and note any codes that are output.

    2. Clear the DTC.

    3. Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the same DTC by simulating the symptoms indicated by the DTC.

      Result
      Result Proceed to
      No DTCs output A
      DTC B2311 is output B
      DTC B2312 is output B
      DTC B2313 is output B
      CAN communication system DTC output reoccur (for LHD) C
      CAN communication system DTC output reoccur (for RHD) D
      LIN communication system DTC output reoccur E

    B

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

    C

    GO TO CAN COMMUNICATION SYSTEM (for LHD) Click here

    D

    GO TO CAN COMMUNICATION SYSTEM (for RHD) Click here

    E

    GO TO LIN COMMUNICATION SYSTEM Click here

    A

  5. PROBLEM SYMPTOMS TABLE

    Result
    Result Proceed to
    Fault not listed in problem symptoms table A
    Fault listed in problem symptoms table B

    B

    GO TO STEP 7 Click here

    A

  6. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Operation Check.

      Click here

    2. Terminals of ECU.

      Click here

    3. Data List / Active Test.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  7. REPAIR OR REPLACE

    Result
    Result Proceed to
    Door window regulator and power window regulator motor assembly is not replaced or removed/installed. A
    Door window regulator and power window regulator motor assembly is replaced or removed/installed. B

    B

    GO TO STEP 9 Click here

    A

  8. PERFORM INITIALIZATION


    1. Initialize the power window regulator motor.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  9. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END