TRIP SWITCH REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. DISABLE AUTOAWAY/RETURN FUNCTION

   
   

   1. Disable the autoaway/return function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the autoaway/return function to be disabled when the engine switch is turned off.

   2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully retract and tilt up the steering column assembly.

   3. Turn the engine switch off.

2. REMOVE INSTRUMENT SIDE PANEL LH

   Click here

3. REMOVE INSTRUMENT PANEL ORNAMENT

   Click here

4. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

5. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

   Click here

6. REMOVE TRIP SWITCH

   
   

   1. 

      w/o Night View System:

      Detach the 2 claws and remove the trip switch from the No. 2 instrument cluster finish panel sub-assembly.

   2. 

      w/ Night View System:

      Detach the 2 claws and remove the trip switch from the No. 2 instrument cluster finish panel sub-assembly.