DOOR CONTROL TRANSMITTER REMOVAL

PROCEDURE

1. REPLACE TRANSMITTER BATTERY (for Standard, for Type A)

   Note

   Take extra care when handling these precision electronic components.

   
   

   1. 

      Slide and hold the release knob in the direction indicated by the arrow in the illustration. Then take the mechanical key out of the case.

   2. 

      Text in Illustration

      *1	Protective Tape

      Insert a screwdriver, into the gap and turn the screwdriver to detach the transmitter housing cover.

      Tech Tips

      Tape the screwdriver tip before use.

   3. 

      Text in Illustration

      *1	Protective Tape

      Insert a screwdriver, into the gap and remove the battery (lithium battery: CR1632).

      Note

      
      

      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.

      • Do not push the terminals with your finger.

      • Do not forcibly pry up the battery. The terminals may be damaged.

      • Do not touch the battery with wet hands. Water may cause rust.

      • Do not touch or move any components inside the transmitter. It may interfere with proper operation.

2. REPLACE TRANSMITTER BATTERY (for Standard, for Type B)

   Note

   Take extra care when handling these precision electronic components.

   
   

   1. 

      Slide and hold the release knob in the direction indicated by the arrow in the illustration. Then take the mechanical key out of the case.

   2. 

      Slide the transmitter housing cover and remove the transmitter housing cover as shown in the illustration.

   3. 

      Remove the 4 screws and remove the transmitter battery housing cover and O-ring.

      Note

      When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.

   4. 

      Text in Illustration

      *1	Protective Tape

      Insert a screwdriver, into the gap and remove the battery (lithium battery: CR1632).

      Note

      
      

      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.

      • Do not push the terminals with your finger.

      • Do not forcibly pry up the battery. The terminals may be damaged.

      • Do not touch the battery with wet hands. Water may cause rust.

      • Do not touch or move any components inside the transmitter. It may interfere with proper operation.

3. REMOVE TRANSMITTER (CARD KEY) BATTERY (for Card Type)

   
   

   1. 

      Lightly hold and pull the battery cover out in the direction indicated by the arrow in the illustration.

      Note

      Do not insert a screwdriver etc. between the case and battery cover and forcefully bend the battery cover. This will deform the battery cover.

      Tech Tips

      
      

      • If the battery cover is held too firmly, it becomes harder to pull out.

      • If the cover is slippery and it is difficult to pull it out, use non-slip gloves to pull the cover out.

   2. 

      Remove the transmitter (card key) battery (lithium battery: CR2412).