POWER DOOR LOCK CONTROL SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use these procedures to troubleshoot the power door lock control system.

  • *: Use the intelligent tester.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT BATTERY VOLTAGE

    Standard voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding.

    Result
    Proceed to
    NEXT

    NEXT

  3. CHECK FOR DTC (ELECTRICAL POWER CONTROL SYSTEM)*


    1. Using the intelligent tester, check if the electric power control system is functioning normally.

      Result
      Result Proceed to
      DTC B22B3 is not output A
      DTC B22B3 is output B

    B

    GO TO ELECTRIC POWER CONTROL SYSTEM Click here

    A

  4. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Use the intelligent tester to check if the CAN Communication System is functioning normally.

      Result
      Result Proceed to
      CAN DTC is not output A
      CAN DTC is output (for LHD) B
      CAN DTC is output (for RHD) C

    B

    GO TO CAN COMMUNICATION SYSTEM (for LHD) Click here

    C

    GO TO CAN COMMUNICATION SYSTEM (for RHD) Click here

    A

  5. CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*


    1. Use the intelligent tester to check if the LIN Communication System is functioning normally.

      Result
      Result Proceed to
      LIN DTC is not output A
      LIN DTC is output B

    B

    GO TO LIN COMMUNICATION SYSTEM Click here

    A

  6. CHECK FOR DTC*


    1. Check for DTCs.

      Click here

    2. Clear the DTCs.

      Click here

    3. Recheck for DTCs.

      Click here

      Result
      Result Proceed to
      DTC does not reoccur A
      DTC reoccurs B

    B

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

    A

  7. PROBLEM SYMPTOMS TABLE

    Result
    Result Proceed to
    Fault is not listed on problem symptoms table A
    Fault is listed on problem symptoms table B

    B

    GO TO STEP 9 Click here

    A

  8. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Operation Check

      Click here

    2. Data List / Active Test

      Click here

    3. Terminals of ECU.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  9. ADJUST, REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT

  10. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END