CONDENSER(for 2WD) REMOVAL

PROCEDURE

1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

   Click here

2. REMOVE FRONT BUMPER COVER

   Click here

3. REMOVE V-BANK COVER SUB-ASSEMBLY

   Click here

4. REMOVE NO. 1 AIR CLEANER INLET

   Click here

5. REMOVE NO. 1 ENGINE UNDER COVER

   Click here

6. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

   Click here

7. DISCONNECT HOOD LOCK CONTROL CABLE COVER

   Click here

8. DISCONNECT HOOD LOCK ASSEMBLY

   Click here

9. REMOVE RADIATOR UPPER SUPPORT SUB-ASSEMBLY

   Click here

10. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY

    
    

    1. 

       Remove the bolt and disconnect the discharge hose sub-assembly from the cooler condenser assembly.

       Note

       
       

       • When loosening the bolt, do not allow any tools to contact the hose.

       • When loosening the bolt, hold a part of the hose near the connector.

    2. Remove the O-ring from the discharge hose sub-assembly.

       Note

       Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

11. DISCONNECT LIQUID TUBE SUB-ASSEMBLY A

    
    

    1. 

       Remove the bolt and disconnect the liquid tube sub-assembly A from the cooler condenser.

       Note

       
       

       • When loosening the bolt, do not allow any tools to contact the tube.

       • When loosening the bolt, hold a part of the tube near the connector.

    2. Remove the O-ring from the liquid tube sub-assembly A.

       Note

       Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

12. REMOVE COOLER CONDENSER ASSEMBLY

    
    

    1. 

       Remove the 4 bolts and cooler condenser assembly.

13. REMOVE COOLER DRYER

    
    

    1. 

       Using a 14 mm socket hexagon wrench, remove the cap from the modulator.

    2. 

       Remove the O-ring from the cap.

    3. 

       Using pliers, remove the cooler dryer.