FRONT SEAT OUTER BELT ASSEMBLY INSPECTION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY

    A001A0KE01

    CAUTION:

    Do not disassemble the retractor.


    1. Before installing the seat belt, check the ELR.


      1. When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks. If the operation is not as specified, replace the seat belt assembly.

    2. A001E0V

      Check the tension reducer operation.

      A001DEDE01

      Note

      Do not apply battery voltage to the pretensioner connector.


      1. Connect the battery's positive (+) lead to terminal 1 of the tension reducer connector and the negative (-) lead to terminal 2.

      2. Check that an operating sound is heard when the magnetized solenoid is attracting the plunger.

      3. Pull out the seat belt and let it retract. Listen to the operating sound.

      4. Pull out the seat belt again, disconnect the battery's negative (-) lead and let it retract. Listen to the operating sound again and check that the operating sound volume has increased.

        If the result is not as specified, replace the outer belt assembly.

  2. INSPECT HEIGHT ADJUSTABLE ANCHOR MOTOR

    A001FL8E01
    *a No Pin
    *b Upward
    *c Slider
    *d Downward

    Tech Tips


    • When removing the anchor motor from the height adjustable anchor, fix the height adjustable anchor's slider so that it does not move out of position. Fix the slider until the motor is reinstalled.

    • Use the same procedures for the RH side and LH side.


    1. Disconnect the belt anchor adjuster.

    2. Apply battery voltage and check operation of the belt anchor adjuster.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 5

      Battery negative (-) → Terminal 3

      		 Slider moves upward

      Battery positive (+) → Terminal 3

      Battery negative (-) → Terminal 5

      		 Slider moves downward

      If the result is not as specified, replace the motor.

    3. A001EC9E01
      *a Upward
      *b No Pin
      *c Ammeter
      *d Slider

      Check the PTC operation inside the regulator motor.

      Note

      Perform this procedure with the shoulder belt anchor adjuster installed in the vehicle.


      1. Disconnect the driver side shoulder belt anchor adjuster.

      2. Connect the ammeter's positive (+) lead to terminal 5 of the wire harness side connector and the negative (-) lead to the battery's negative terminal.

      3. Connect the battery's positive (+) lead to terminal 5 and negative (-) lead to terminal 3, and slide the anchor to the upward position.

      4. Continue to apply voltage, and check that the current changes to less than 1 A within 6 to 46 seconds.

      5. Disconnect the leads from the terminals.

      6. A001DQBE01
        *a No Pin
        *b Downward
        *c Slider

        Approximately 60 seconds later, connect the battery's positive (+) lead to terminal 3 and the negative (-) lead to terminal 5, and check that the shoulder belt anchor adjuster slides to the downward position.

        If the result is not as specified replace the motor assembly.