DRIVER MONITOR CAMERA REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. DISABLE AUTO TILT AWAY FUNCTION

   
   

   1. Disable the Autoaway/Return function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the Autoaway/Return function to be disabled when the engine switch is turned off.

   2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.

   3. Turn the engine switch off.

2. REMOVE INSTRUMENT SIDE PANEL LH

   Click here

3. REMOVE INSTRUMENT PANEL ORNAMENT

   Click here

4. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

5. REMOVE STEERING COLUMN COVER

   
   

   1. for Lower Side:

      
      

      1. Remove the 3 screws.

         
      2. 

         Detach the 2 claws to remove the steering column cover.

   2. for Upper Side:

      
      

      1. 

         Detach the 4 clips to remove the instrument cluster finish panel sub-assembly.

      2. 

         Disconnect the driver monitor camera connector.

      3. 

         Detach the claw to remove the steering column cover.

6. REMOVE DRIVER MONITOR BRACKET

   
   

   1. 

      Detach the claw and disconnect the driver monitor camera connector.

   2. Remove the screw.

   3. Detach the guide and remove the driver monitor bracket.

7. REMOVE DRIVER MONITOR CAMERA

   
   

   1. 

      Remove the 2 screws.

   2. Detach the 2 claws and remove the driver monitor camera.