SEAT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL SEAT POSITION AIRBAG SENSOR


    1. A001EXKE05
      *1 Seat Position Sensor
      *2 Feeler Gauge
      *3 1.0 mm
      *4 Seat Rail

      Using a feeler gauge 1.0 mm (0.039 in.), install the seat position sensor.

      Note


      • If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.

      • When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

      Tech Tips

      Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.023 in.) to 1.4 mm (0.055 in.).

    2. Using a T30 "TORX" socket wrench, install the "TORX" screw to install the seat position sensor.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
    3. Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.023 in.) to 1.4 mm (0.055 in.).

    4. Check that there is no looseness in the installation parts of the seat position sensor.

    5. Connect the connector.

    6. Install the seat slide position sensor protector to the seat position sensor.

  2. INSTALL FRONT SEAT ASSEMBLY LH

    Click here

  3. CHECK SRS WARNING LIGHT

    Click here