ELECTRIC POWER CONTROL SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use these procedures to troubleshoot the electric power control system.

  • *: Use the intelligent tester.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT BATTERY VOLTAGE

    Standard voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding.

    Result
    Proceed to
    NEXT

    NEXT

  3. INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Using the intelligent tester, check if the CAN communication system is functioning normally.

      Result
      Result Proceed to
      CAN DTC is not output A
      CAN DTC is output (for LHD) B
      CAN DTC is output (for RHD) C

    B

    GO TO CAN COMMUNICATION SYSTEM (for LHD) Click here

    C

    GO TO CAN COMMUNICATION SYSTEM (for RHD) Click here

    A

  4. CHECK DATA LIST / ACTIVE TEST*


    1. Check the Data List's load control history (number of items) and the final load control history*. Then write down the information.

      Tech Tips

      Refer to the following description for information about "final load control history".

      Result
      Proceed to
      NEXT

    NEXT

  5. CHECK FOR DTC*


    1. Check for DTCs and write them down.

    2. Delete the DTC.

    3. Check for DTC again.

      Result
      Result Proceed to
      No DTCs, symptom confirmation and symptom simulation can be performed A
      No DTCs, symptom confirmation and symptom simulation cannot be performed B
      DTC output C

    B

    GO TO INTRODUCTION Click here

    C

    GO TO STEP 8 Click here

    A

  6. PROBLEM SYMPTOMS TABLE

    Result
    Result Proceed to
    Fault is not listed in problem symptoms table A
    Fault is listed in problem symptoms table B

    B

    GO TO STEP 8 Click here

    A

  7. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Data List / Active Test

      Click here

    2. Terminals of ECU

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  8. ADJUST, REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT

  9. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END