NIGHT VIEW SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips

*: Use the GTS.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. CUSTOMER PROBLEM ANALYSIS

    Result
    Proceed to
    NEXT

    NEXT

  3. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage with the engine switch off.

      Standard Voltage
      11 to 14 V

      Tech Tips

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

      Result
      Proceed to
      NEXT

    NEXT

  4. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Use the GTS to check if the CAN communication system is functioning normally.

      for LHD: Click here

      for RHD: Click here

      Result
      Result Proceed to
      CAN DTC is not output A
      CAN DTC is output (for LHD) B
      CAN DTC is output (for RHD) C

    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    C

    GO TO CAN COMMUNICATION SYSTEM Click here

    A

  5. CHECK FOR DTC*


    1. Clear the DTCs.

      Click here

    2. Recheck for DTCs.

      Click here


      1. Attempt to reproduce malfunction symptoms according to the recorded DTCs and check if the DTCs are stored again.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

    B

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

    A

  6. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table.

      Click here

      Result
      Result Proceed to
      Fault is not listed in problem symptoms table A
      Fault is listed in problem symptoms table B

    B

    ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

    A

  7. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Check Data List / Active Test

      Click here

    2. Check Terminals of ECU

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  8. REPAIR OR REPLACEMENT

    Note

    When the No. 1 night view ECU and/or object recognition camera (night view camera) is replaced, perform object recognition camera (night view camera) adjustment.

    Click here

    Result
    Proceed to
    NEXT

    NEXT

  9. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END