TELEMATICS TRANSCEIVER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL NO. 2 TELEPHONE BRACKET


    1. Install the No. 2 telephone bracket with the bolt.

  2. INSTALL NO. 1 TELEPHONE BRACKET


    1. Install the No. 1 telephone bracket with the bolt.

  3. INSTALL TELEMATICS TRANSCEIVER


    1. Connect each connector.

    2. Install the telematics transceiver with the bolt and nut.

  4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  5. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

    Click here

  6. INSTALL LOWER INSTRUMENT PANEL

    Click here

  7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  8. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

  9. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

    Click here

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  11. INSTALL COWL TOP VENTILATOR LOUVER RH

    Click here

  12. CHECK SRS WARNING LIGHT

    Click here

  13. REGISTRATION TELEMATICS TRANSCEIVER


    1. When replacing the multi-media module receiver assembly or telematics transceiver, perform the vehicle contract setting Click here.