ABS MOTOR RELAY ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

PROCEDURE


  1. CHECK ABS MOTOR RELAY (ABS MTR1)

    Tech Tips

    The ABS motor relay (ABS MTR1) cannot be removed and inspected, as it is an internal relay of the engine room junction block.


    1. Turn the engine switch off.

    2. Connect the intelligent tester to the DLC3.

    3. A001ADVE03
      Text in Illustration
      *1 Terminal Cover
      *2 Engine Room No. 2 Junction Block

      Remove the relay inspection terminal cover of the engine room No. 2 junction block.

    4. Turn the engine switch on (IG).

    5. Using the intelligent tester, perform the Active Test for the ABS motor relay (ABS MTR1) and measure the voltage between the relay inspection terminals of the engine room junction block.

      Tech Tips

      As the ABS motor relay (ABS MTR1) is a semiconductor relay, there are no operation sounds.

      A001DG0E11
      Standard voltage
      Tester Connection Switch Condition Specified Condition
      Terminal 23 or 24 - Body ground Motor relay: ON 11 to 14 V
      Motor relay: OFF 0 V
      Terminal 25 or 26 - Body ground - 11 to 14 V
      Text in Illustration
      *1 Engine Room No. 2 Junction Block - -
      *a Terminal for Relay Inspection *b Inner Circuit

      If the result is not as specified, check the harness wires and connectors and replace them as necessary.

      If the harness wires and connectors are in good condition, replace the engine room junction block assembly.

  2. CHECK ABS MOTOR RELAY (ABS MTR2)


    1. Remove the ABS motor relay from the No. 3 relay block.

    2. A001A7P

      Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      3 - 5 When battery voltage is not applied to terminals 1 and 2 10 kΩ or higher
      3 - 5 When battery voltage is applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the relay.

    3. Install the ABS motor relay.