REAR LOWER ARM INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

    A001BJUE04
    *1 No. 2 Suspension Toe Adjust Plate

    1. Temporarily install the No. 2 suspension arm with the No. 2 suspension toe adjust plate, rear suspension attachment and nut to the suspension member.

    2. A001C0G

      Install the stud of the suspension arm, and temporarily install a washer, nut and the bolt to the axle carrier.

  2. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

    A001CAZ

    1. Temporarily install the No. 1 suspension arm with the bolt and nut to the suspension member.

    2. A001CJK

      Install the stud of the suspension arm, and temporarily install a new nut to the axle carrier.

  3. TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH


    1. Tighten the bolt and nut.

      Torque:
      72 N*m  { 734 kgf*cm, 53 ft.*lbf }
      for bolt
      118 N*m  { 1203 kgf*cm, 87 ft.*lbf }
      for nut

  4. TEMPORARILY CONNECT REAR SHOCK ABSORBER ASSEMBLY LH (w/o Air Suspension)

    Click here

  5. TEMPORARILY CONNECT PNEUMATIC CYLINDER WITH REAR SHOCK ABSORBER ASSEMBLY LH (w/ Air Suspension)

    Click here

  6. INSTALL REAR STABILIZER LINK ASSEMBLY LH

    Click here

  7. STABILIZE SUSPENSION


    1. Stabilize the suspension (w/o Air Suspension) Click here.

    2. Stabilize the suspension (w/ Air Suspension) Click here.

  8. TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH


    1. Tighten the 2 nuts.

      Torque:
      150 N*m  { 1530 kgf*cm, 111 ft.*lbf }
      for suspension member side
      225 N*m  { 2294 kgf*cm, 166 ft.*lbf }
      for axle carrier side

  9. CONNECT REAR SHOCK ABSORBER ASSEMBLY LH (w/o Air Suspension)

    Click here

  10. CONNECT PNEUMATIC CYLINDER WITH REAR SHOCK ABSORBER ASSEMBLY LH (w/ Air Suspension)

    Click here

  11. INSTALL REAR SPEED SENSOR LH

    Click here

  12. INSTALL LOAD SENSING VALVE SENSOR BRACKET

    Click here

  13. INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR

    Click here

  14. INSTALL REAR WHEEL

    Torque:
    140 N*m  { 1428 kgf*cm, 103 ft.*lbf }

  15. CHECK SUSPENSION CONTROL SYSTEM (for Air suspension)


    1. Check the suspension control system Click here.

  16. INSPECT AND ADJUST REAR WHEEL ALIGNMENT


    1. Inspect and adjust the rear wheel alignment Click here.

  17. CHECK SPEED SENSOR SIGNAL


    1. Check the speed sensor signal Click here.

  18. REMOVE HEADLIGHT ASSEMBLY

    Click here

  19. ADJUST OBJECT RECOGNITION CAMERA

    Click here