FRONT STABILIZER BAR(for AWD) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE

INSTALL FRONT NO. 1 STABILIZER BAR BUSH

Install the 2 front No. 1 stabilizer bar bushes outside of the bush stoppers on the front stabilizer bar as shown in the illustration.

Note

Make sure to face the front No. 1 stabilizer bar bush's seam to the lower rear of the vehicle.

TEMPORARILY INSTALL FRONT STABILIZER BAR
*1 Vehicle Top

*2 Vehicle Frontside
1. Temporarily install the front stabilizer bar and front No. 1 stabilizer bracket LH and RH with the 4 bolts in the direction shown in the illustration.
INSTALL FRONT NO. 1 STABILIZER BRACKET LH
1. Install the front No. 1 stabilizer bracket LH with the 2 bolts.
  
  Torque:
  
  115 N*m { 1173 kgf*cm, 85 ft.*lbf }
2. Install the wire harness bracket with the bolt.
  
  Torque:
  
  22 N*m { 224 kgf*cm, 16 ft.*lbf }
INSTALL FRONT NO. 1 STABILIZER BRACKET RH
1. Install the front No. 1 stabilizer bracket RH with the 2 bolts.
  
  Torque:
  
  115 N*m { 1173 kgf*cm, 85 ft.*lbf }
INSTALL FRONT STABILIZER LINK ASSEMBLY LH
1. Install the front stabilizer link with the 2 nuts.
  
  Torque:
  
  85 N*m { 867 kgf*cm, 63 ft.*lbf }
  
  Tech Tips
  
  If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.
INSTALL FRONT STABILIZER LINK ASSEMBLY RH

Tech Tips

Install the RH side following the same procedures as the LH side.
INSTALL FRONT LOWER SUSPENSION MEMBER PROTECTOR

Click here
INSTALL NO. 1 ENGINE UNDER COVER

Click here
INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

Click here
INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

Click here
INSTALL NO. 2 ENGINE UNDER COVER

Click here
INSTALL FRONT CENTER FLOOR COVER

Click here

*1	Vehicle Top
*2	Vehicle Frontside