FRONT LOWER BALL JOINT(for AWD) INSPECTION

PROCEDURE


  1. INSPECT FRONT LOWER BALL JOINT ASSEMBLY

    A001DF2

    1. Inspect the turning of the front lower ball joint.


      1. Flip the ball joint stud back and forth 5 times as shown in the illustration.

      2. Temporarily install the nut, and use a torque wrench to turn the nut continuously at a rate of 3 to 5 seconds per turn. Take the torque reading on the 5th turn.

        Standard turning torque
        6.0 N*m (61.1 kgf*cm, 53.1 in.*lbf) or less

        If the result is not as specified, replace the front lower ball joint assembly.

    2. Check the dust boot for cracks or grease leakage.