SUSPENSION CONTROL ECU(for RHD) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL SUSPENSION CONTROL ECU


    1. A001D0I

      Install the suspension control ECU to the bracket with the 2 nuts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note


      • Avoid any impact to the suspension control ECU.

      • Do not drop the ECU. If it is dropped, replace it with a new one.

  2. INSTALL NETWORK GATEWAY ECU (w/ Network Gateway ECU)

    Click here

  3. INSTALL SUSPENSION CONTROL ECU WITH BRACKET (w/o Network Gateway ECU)


    1. A001BO5

      Install the ECU with bracket with the 2 nuts.

    2. A001DZF

      Connect the connectors.

      Note

      If the suspension control ECU is replaced with a new one, enter test mode and perform registration of vehicle identification information Click here.

  4. CONNECT CONNECTORS (w/ Driver Monitor ECU)

  5. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Click here

  6. ADJUST VEHICLE HEIGHT

    Note

    If the suspension control ECU has been replaced, be sure to adjust the vehicle height Click here.