REAR AXLE HUB ON-VEHICLE INSPECTION

PROCEDURE


  1. REMOVE REAR WHEEL

  2. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  3. REMOVE REAR DISC

    Click here

  4. INSPECT REAR AXLE HUB BEARING LOOSENESS


    1. A0019PC

      Using a dial indicator, check for looseness near the center of the axle hub.

      Maximum
      0.05 mm (0.0020 in.)

      Note

      Ensure that the dial indicator is set at a right angle to the measurement surface.

      If the looseness exceeds the maximum, replace the axle hub.

  5. INSPECT REAR AXLE HUB RUNOUT


    1. A001CKS

      Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

      Maximum
      0.05 mm (0.0020 in.)

      Note

      Ensure that the dial indicator is set at a right angle to the measurement surface.

      If the runout exceeds the maximum, replace the axle hub.

  6. INSTALL REAR DISC

    Click here

  7. ADJUST PARKING BRAKE SHOE CLEARANCE

    Click here

  8. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  9. INSTALL REAR WHEEL

    Torque:
    140 N*m  { 1428 kgf*cm, 103 ft.*lbf }