HEATED OXYGEN SENSOR(for AWD) INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    1. A001BWPE01
      *1 Fulcrum Length

      Using SST, install the heated oxygen sensor to the front exhaust pipe.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Tech Tips


      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Click here.

      • Make sure SST and the wrench are connected in a straight line.

    2. Connect the heated oxygen sensor connector.

  2. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    1. Exterior Side:


      1. A001F0IE03
        *1 Grommet
        *2 Fulcrum Length

        Using SST, install the heated oxygen sensor to the front exhaust pipe.

        SST
        09224-00010
        Torque:
        without SST
        44 N*m  { 449 kgf*cm, 32 ft.*lbf }
        with SST
        40 N*m  { 408 kgf*cm, 30 ft.*lbf }

        Tech Tips


        • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Click here.

        • Make sure SST and the wrench are connected in a straight line.

      2. Install the grommet to the vehicle.

    2. A001COR

      Interior Side:

      Connect the heated oxygen sensor connector.

  3. INSTALL REAR NO. 2 AIR DUCT

  4. INSTALL FRONT FLOOR SILENCER PAD RH

  5. INSTALL COWL SIDE TRIM BOARD RH

    Click here

  6. INSTALL FRONT DOOR SCUFF PLATE RH

    Click here