FRONT AXLE HUB(for 2WD) ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

PROCEDURE


  1. REMOVE FRONT WHEEL

  2. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  3. REMOVE FRONT DISC

    Click here

  4. INSPECT FRONT AXLE HUB BEARING LOOSENESS


    1. A0019WE

      Using a dial indicator, measure the looseness near the center of the axle hub.

      Maximum
      0.05 mm (0.0020 in.)

      Note

      Ensure that the dial indicator is set at a right angle to the measurement surface.

      If the looseness exceeds the maximum, replace the axle hub.

  5. INSPECT FRONT AXLE HUB RUNOUT


    1. A0019UW

      Using a dial indicator, measure the runout on the surface of the axle hub outside the hub bolt.

      Maximum
      0.05 mm (0.0020 in.)

      Note

      Ensure that the dial indicator is set at a right angle to the measurement surface.

      If the runout exceeds the maximum, replace the axle hub.

  6. INSTALL FRONT DISC

    Click here

  7. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  8. INSTALL FRONT WHEEL

    Torque:
    140 N*m  { 1428 kgf*cm, 103 ft.*lbf }