FRONT DRIVE SHAFT ASSEMBLY INSPECTION

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE


  1. INSPECT FRONT DRIVE SHAFT ASSEMBLY


    1. A001DW0

      Check that there is no excessive play in the radial direction of the outboard joint.

    2. Check that the inboard joint slides smoothly in the thrust direction.

    3. Check that there is no severe play in the radial direction of the inboard joint.

    4. Check the 2 joint boots for damage.

    5. A00198UE06
      Text in Illustration
      *A for LH Side
      *B for RH Side

      Check that the 2 joint boots are not stretched or contracted when the front drive shaft is at the standard length.

      Length (A)
      Item Length
      LH Side 541.8 mm (1.78 ft.)
      RH Side 955.3 mm (3.13 ft.)

      Note

      Keep the front drive shaft level during inspection.

      If the joint boots are stretched or contracted, correct them.