OIL PUMP REASSEMBLY

PROCEDURE


  1. INSTALL OIL PUMP FRONT OIL SEAL

    A001CQME01

    1. Using SST and a hammer, tap in a new oil seal.

      SST
      09350-30020   ( 09351-32140 )
      Standard depth
      0 +/-0.2 mm (0.008 in.)

      Tech Tips

      The oil seal end should be flush with the outer edge of the pump body.

    2. Coat the lip of the oil seal with MP grease.

  2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY


    1. Place the oil pump body on the torque converter clutch.

  3. INSTALL FRONT OIL PUMP DRIVEN GEAR

    A001AXF

    1. Coat the driven gear with ATF.

    2. Install the driven gear to the oil pump body.

  4. INSTALL FRONT OIL PUMP DRIVE GEAR

    A001A8Y

    1. Coat the drive gear with ATF.

    2. Install the drive gear to the oil pump body.

  5. INSTALL FRONT OIL PUMP BODY O-RING

    A001FFKE01
    *1 New O-Ring

    1. Coat a new O-ring with ATF.

    2. Install the O-ring to the oil pump body.

  6. INSTALL STATOR SHAFT ASSEMBLY

    A001FTV

    1. Align the stator shaft with each bolt hole and install it.

    2. Install the 2 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

  7. INSTALL STATOR SHAFT CLUTCH DRUM THRUST WASHER

    A001BWH

    1. Align the 2 claws and install the thrust washer.

  8. INSTALL NO. 1 BRAKE PISTON


    1. A00197TE02
      *1 New O-Ring

      Coat 2 new O-rings with ATF and install them to the No. 1 brake piston.

    2. A001CH1

      Install the No. 1 brake piston and brake piston return spring sub-assembly.

    3. Using a T30 ''TORX'' wrench, install the 5 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

  9. INSPECT OIL PUMP DRIVE GEAR ROTATION

    Click here

  10. INSTALL CLUTCH DRUM OIL SEAL RING

    A001C9KE03
    *a New Oil Seal Ring

    1. Coat 4 new oil seal rings with ATF.

    2. Squeeze the ends of the 4 oil seal rings so that the gap becomes 8 mm (0.32 in.) or less, and then install them to the stator shaft groove.

      Note

      Do not expand the ring ends excessively.

      Tech Tips

      After installing the oil seal rings, check that they rotate smoothly.

  11. INSTALL OIL PUMP O-RING

    A001FQQE01
    *1 New O-Ring

    1. Install a new O-ring to the oil pump.