DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL(for LSD) REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. DRAIN DIFFERENTIAL OIL

    Click here

  3. REMOVE REAR DRIVE SHAFT ASSEMBLY

    Click here

  4. REMOVE REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL


    1. A001AUQE02

      Using SST, remove the rear differential side gear shaft oil seal.

      SST
      09308-00010

  5. INSTALL REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL


    1. A0019SCE04
      *1 -0.5 to 0.5 mm

      Using SST and a hammer, install a new rear differential side gear shaft oil seal.

      SST
      09223-15030
      09950-70010   ( 09951-07200 )
      Oil seal installation depth
      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      Note


      • Make sure to check the identification marks on the oil seals before installation because the part numbers differ between the left and right sides.

      • To ensure a proper seal, evenly tap in the rear differential side gear shaft oil seal.

      • After installing the oil seal, tap it in until the surface is flush with the rear differential carrier.

  6. INSTALL REAR DRIVE SHAFT ASSEMBLY

    Click here

  7. ADD DIFFERENTIAL OIL

    Click here

  8. INSPECT FOR DIFFERENTIAL OIL LEAK

  9. ADJUST PARKING BRAKE

    Click here

  10. INSTALL REAR WHEEL

    Torque:
    140 N*m  { 1428 kgf*cm, 103 ft.*lbf }

  11. CHECK FOR SPEED SENSOR SIGNAL

    Click here

  12. PERFORM PARKING BRAKE SHOE BEDDING

    Click here

  13. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here