DIFFERENTIAL MOUNT CUSHION REMOVAL

PROCEDURE


  1. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

    Click here

  2. REMOVE NO. 2 DIFFERENTIAL SUPPORT PROTECTOR

    Click here

  3. REMOVE NO. 1 DIFFERENTIAL SUPPORT PROTECTOR

    Click here

  4. REMOVE REAR SUSPENSION MEMBER BRACE LH

    Click here

  5. REMOVE REAR SUSPENSION MEMBER BRACE RH

    Click here

  6. REMOVE REAR AXLE ASSEMBLY LH

    Click here

  7. REMOVE REAR AXLE ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  8. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY WITH DRIVE SHAFT


    1. A001F4TE03

      Support the rear differential carrier assembly (with drive shaft) with a transmission jack.

      CAUTION:


      • As the rear differential carrier assembly (with drive shaft) is very heavy, securely support it with the transmission jack.

      • Perform this procedure with several people supporting the rear differential carrier assembly (with drive shaft) so that it does not tilt or fall.

    2. Using SST or a 12 mm socket hexagon wrench, remove the 3 bolts (A) from the rear No. 1 and No. 2 differential mount cushions.

      SST
      09249-63010

    3. Remove the 2 bolts (B).

    4. Slowly lower the transmission jack. Then remove the rear differential mount stopper upper and lower, and rear differential carrier assembly from the rear suspension member.

      Note


      • Do not drop the rear differential carrier assembly (with drive shaft).

      • When removing the rear differential carrier assembly (with drive shaft), do not damage the installation surface.

  9. REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Click here

  10. REMOVE REAR SUSPENSION MEMBER DAMPER


    1. A001EGG

      Remove the 3 bolts, and the rear suspension member damper.

  11. REMOVE REAR NO. 1 DIFFERENTIAL MOUNT CUSHION


    1. Pass SST bolts through the area shown in the illustration, and remove the mount cushion No. 1.

      SST
      09316-12010
      09570-24011
      A001C39E02

      Note


      • When removing the mount cushion No. 1, do not allow the rear suspension member to contact SST (09316-12010).

      • Before using SST bolts, apply hypoid gear oil to their threads.

      • Be sure to combine SST properly.

      • Do not install SST bolts at an angle.

      • Make sure SST bolts are tightened equally.

  12. REMOVE REAR NO. 2 DIFFERENTIAL MOUNT CUSHION


    1. Pass SST bolt through the area shown in the illustration, and remove the mount cushion No. 2.

      SST
      09316-12010
      09570-24011
      A001ABRE04

      Note


      • When removing the mount cushion No. 2, do not allow the rear suspension member to contact SST (09316-12010).

      • Before using SST bolt, apply hypoid gear oil to its threads.

      • Be sure to combine SST properly.

      • Do not install SST bolts at an angle.