CRUISE CONTROL SYSTEM TC and CG Terminal Circuit

WIRING DIAGRAM

A001DVGE01

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (DLC3 - ECM AND BODY GROUND)

    A001FM2E02
    *1 Front view of DLC3
    *2 Front view of wire harness connector: (to ECM)

    1. Disconnect the L31 DLC3 connector.

    2. Disconnect the A13 ECM connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      L31-13 (TC) - A13-23 (TC) Always Below 1 Ω
      L31-4 (CG) - Body ground Always Below 1 Ω
      L31-13 (TC) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR