OIL PRESSURE SWITCH INSTALLATION

PROCEDURE


  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. A001AW3E01
      *1 Adhesive

      Apply adhesive to 2 or 3 threads of the switch.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    2. Using a 24 mm deep socket wrench, install the switch.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour after installation.

    3. Connect the switch connector.

  2. INSTALL NO. 1 ENGINE UNDER COVER

    Click here

  3. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH (for AWD)

    Click here

  4. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (for AWD)

    Click here

  5. INSPECT FOR ENGINE OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the area that was worked on.