FUEL PRESSURE REGULATOR DISASSEMBLY

PROCEDURE


  1. REMOVE FUEL SENDER GAUGE ASSEMBLY

    A001AQBE03

    1. Disconnect the fuel sender gauge connector from the fuel suction plate.

    2. Press down on the sender gauge claw labeled A. Then slide the sender gauge upward.

      Note

      Do not touch the resistance plate or contacts of the fuel sender gauge assembly.

  2. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY

    A001CC0

    1. Disconnect the fuel pump connector from the fuel suction plate.

    2. A001DRXE09
      *1 E-Ring

      Using needle nose pliers, remove the E-ring.

    3. Remove the fuel suction plate and spring from the sub-tank.

  3. REMOVE FUEL FILTER


    1. A001D8M

      Disengage the 2 claws and remove the filter from the sub-tank.

  4. REMOVE JET PUMP


    1. A001BULE04
      *1 Screwdriver
      *2 Jet Pump

      Using a screwdriver with the tip taped, remove the jet pump from the sub-tank.

    2. A001ADNE23
      *1 Jet Pump
      *2 O-Ring

      Remove the O-ring from the jet pump.

  5. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

    A001AYS

    1. Disconnect the fuel pump connector from the fuel pump.

    2. A0019ZX

      Detach the 2 claws of the fuel filter and remove the cap.

    3. Remove the fuel pressure regulator from the fuel filter.

    4. Remove the 2 O-rings from the pressure regulator.

  6. REMOVE BRACKET

    A001DXME02
    *1 Bracket

    1. Using a screwdriver with the tip taped, disengage the claw and remove the bracket.