FUEL PRESSURE REGULATOR DISASSEMBLY

PROCEDURE


  1. REMOVE FUEL SENDER GAUGE ASSEMBLY


    1. A001AQBE03

      Disconnect the fuel sender gauge connector from the fuel suction plate.

    2. Press down on the sender gauge claw labeled A. Then slide the sender gauge upward.

      Note

      Do not touch the resistance plate or contacts of the fuel sender gauge assembly.

  2. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY


    1. A001CC0

      Disconnect the fuel pump connector from the fuel suction plate.

    2. A001DRXE09
      *1 E-Ring

      Using needle nose pliers, remove the E-ring.

    3. Remove the fuel suction plate and spring from the sub-tank.

  3. REMOVE FUEL FILTER


    1. A001D8M

      Disengage the 2 claws and remove the filter from the sub-tank.

  4. REMOVE JET PUMP


    1. A001BULE05
      *1 Screwdriver
      *2 Jet Pump

      Using a screwdriver with the tip taped, remove the jet pump from the sub-tank.

    2. A001ADNE25
      *1 Jet Pump
      *2 O-Ring

      Remove the O-ring from the jet pump.

  5. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    1. A0019ZX

      Detach the 2 claws of the fuel filter and remove the cap.

    2. Remove the fuel pressure regulator from the fuel filter.

    3. Remove the 2 O-rings from the pressure regulator.