МАСЛЯНЫЙ НАСОС ПОВТОРНАЯ СБОРКА


  1. INSTALL FRONT OIL PUMP OIL SEAL


    1. A003FEGE01

      Remove the oil pump driven gear.

    2. Using SST and a hammer, install a new oil seal.

      SST
      09350-30020   ( 09351-32140 )

      Tech Tips

      The oil seal end should be flush with the outer edge of the pump body.

    3. Coat the oil seal lip with MP grease.

  2. INSTALL FRONT OIL PUMP DRIVEN GEAR


    1. A003DN4

      Coat the driven gear with ATF.

    2. Install the driven gear to the oil pump body.

  3. INSTALL FRONT OIL PUMP DRIVE GEAR


    1. A003CV8

      Coat the drive gear with ATF.

    2. Install the drive gear to the oil pump body.

  4. INSTALL STATOR SHAFT ASSEMBLY


    1. A003BL9

      Align the stator shaft with each bolt hole.

    2. Install the 13 bolts.

      Torque:
      10 N*m  { 100 kgf*cm, 7 ft.*lbf }

  5. INSTALL STATOR SHAFT THRUST BEARING RACE


    1. A003AHQ

      Coat the thrust bearing race with petroleum jelly.

    2. Align the tap of the bearing race with the hollow of the pump body.

  6. INSTALL CLUTCH DRUM OIL SEAL RING


    1. A003CHN

      Coat the 2 oil seal rings with ATF.

    2. Squeeze the ends of the 2 oil seal rings together with the wrap distance 8 mm (0.31 in.) or less, and then install them to the starter shaft groove.

      Note

      Do not over-spread the ring ends.

      Tech Tips

      After installing the oil seal rings, check that they rotate smoothly.

  7. INSPECT OIL PUMP DRIVE GEAR ROTATION


    1. A003G61

      Make sure the drive gear rotates smoothly.

    2. Remove the oil pump assembly from the torque converter clutch.

  8. INSTALL FRONT OIL PUMP BODY O-RING


    1. A003HWO

      Install the O-ring to the oil pump assembly.