МУФТА ПРЯМОЙ ПОВЫШАЮЩЕЙ ПЕРЕДАЧИ ПОВТОРНАЯ СБОРКА


  1. INSTALL OVERDRIVE PLANETARY GEAR THRUST WASHER NO.3


    1. A003IDQ

      Install the thrust washer to the O/D planetary gear with the groove side facing upward.

  2. INSTALL OVERDRIVE ONE WAY CLUTCH


    1. A003FFRE02

      Install the 2 retainer to the one-way clutch.

    2. Install the one-way clutch into the outer race with the flange side of the one-way clutch facing upward.

    3. A003EWSE02

      Install the O/D one-way clutch and outer race to the O/D planetary gear.

  3. INSTALL OVERDRIVE RETAINING PLATE


    1. A003ERG

      Install the retaining plate.

    2. A003HLF

      Using a screwdriver, install the snap ring.

  4. INSTALL OVERDRIVE PLANETARY RING GEAR FLANGE


    1. A003GPI

      Install the ring gear flange.

    2. A003BWH

      Using a screwdriver, install the snap ring.

  5. INSTALL OVERDRIVE DIRECT CLUTCH PISTON SUB-ASSEMBLY


    1. A003C7W

      Coat new O-rings with ATF, and install them on the O/D direct clutch piston.

    2. Being careful not to damage the O-rings, and press in the direct clutch piston into the clutch drum with both hands.

  6. INSTALL OVERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY


    1. A003BVN

      Install the piston return spring to the piston.

    2. A003AL2E02

      Place SST on the spring retainer, and compress the return spring with a press.

      Note

      Stop compressing when the spring sheet is lowered to the place 1 to2mm(0.039 to 0.078 in.) from the snap ring groove, preventing the spring sheet from being deformed.

    3. Using a screwdriver, install the snap ring. Be sure the end gap of the snap ring is not aligned with the spring retainer claw.

  7. INSTALL OVERDRIVE DIRECT CLUTCH DISC


    1. A003G9NE02

      Install the 2 plates and discs.

      Install in order
      P = Plate D = Disc
      P - D - P - D
    2. A003B4U

      Install the flange with the flat end facing downward.

    3. A003FBZ

      Using a screwdriver, install the snap ring.

  8. INSPECT OVERDRIVE DIRECT CLUTCH PISTON SUB-ASSEMBLY


    1. A003HE4

      Check that the check ball is free by shaking the piston.

    2. Check that the valve does not have leaks by applying low-pressure compressed air.

  9. INSTALL OVERDRIVE DIRECT CLUTCH DRUM SUB-ASSEMBLY


    1. A003I8G

      Align the flukes of the discs in the direct clutch.

    2. Install the direct clutch assembly onto the O/D planetary gear.

  10. INSPECT OVERDRIVE ONE WAY CLUTCH


    1. A003FHYE03

      Hold the O/D direct clutch drum, and turn the input shaft. Check that the input shaft can be turned freely clockwise and locked counterclockwise.