Click here

ТОРМОЗ ОБЕСПЕЧЕНИЯ РЕЖИМА ТОРМОЖЕНИЯ ДВИГАТЕЛЕМ НА 2-Й ПЕРЕДАЧЕ ПОВТОРНАЯ СБОРКА

Click here
Click here
  1. Click here

    INSPECT 2ND COAST BRAKE BAND ASSEMBLY


    1. A003DDWE02

      If the lining of the brake band is peeled off or discolored, or even if only a part of the printed numbers are corroded, replace the brake band.

      Tip:

      Before assembling the new band, soak it in ATF for at least 15 minutes.

  2. Click here

    INSTALL 2ND COAST BRAKE PISTON

    When the piston rod stroke is outside the standard value even if the brake band works normally, replace the rod with a new one.

    Tip:

    There are 2 different lengths for piston rod.

    Piston rod length
    Number of grooves Thickness mm (in.)
    0 78.40 (3.087)
    1 79.90 (3.146)

    1. A003CM8E02

      Install the washer plate, the compression spring and the piston to the piston rod.

    2. A003AGP

      Firmly hold down the piston, then compress the compression spring.

    3. Using needle nose pliers, install the E-ring.

  3. Click here

    INSTALL 2ND COAST BRAKE PISTON OIL SEAL RING


    1. A003AX7

      Coat the oil seal ring with ATF.

    2. Install the oil seal ring to the piston groove, then snug it down by squeezing its ends together.

      Note:

      Do not over-spread the ring ends.