Click here

ГЕНЕРАТОР СНЯТИЕ

Click here
Click here
  1. Click here

    DISCONNECT NEGATIVE BATTERY CABLE

  2. Click here

    REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)

  3. Click here

    REMOVE FRONT DOOR SCUFF PLATE RH

  4. Click here

    REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)

    Tip:

    Perform the same procedure as above on the opposite side. (Click here)

  5. Click here

    REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)

    Tip:

    Perform the same procedure as above on the opposite side. (Click here)

  6. Click here

    REMOVE ENGINE SERVICE HOLE SUB COVER ASSEMBLY


    1. Заверните коврик и снимите вспомогательную крышку технологического отверстия двигателя.

  7. Click here

    REMOVE FENDER APRON MUDGUARD SEAL RH

  8. Click here

    REMOVE FAN & GENERATOR V BELT


    1. A003AQSE03

      Снимите приводной ремень, повернув шкив натяжителя по часовой стрелке с помощью установочного болта шкива, чтобы ослабить натяжение ремня.

  9. Click here

    SEPARATE COMPRESSOR AND MAGNETIC CLUTCH (w/ Air Conditioning System)


    1. Отсоедините разъем.

    2. A003GDE

      Выверните 4 болта и снимите компрессор и электромагнитную муфту.

  10. Click here

    REMOVE AIR TUBE ASSEMBLY


    1. Remove the 2 clamps, 2 bolts and air tube assembly.

  11. Click here

    REMOVE AIR CLEANER HOSE ASSEMBLY


    1. Remove the bolt and air cleaner hose assembly.

  12. Click here

    REMOVE VENTILATION PIPE


    1. Выверните болт и снимите вентиляционный патрубок.

  13. Click here

    REMOVE COMPRESSOR OUTLET ELBOW


    1. A003EV8

      Remove the 2 bolts and 2 clamps, then remove the compressor outlet elbow.

  14. Click here

    REMOVE IDLE NO.2 PULLEY ASSEMBLY (w/ Air Conditioning System)


    1. A003H7CE01

      Remove the bolt and washer, then remove the idle No.2 pulley assembly.

  15. Click here

    REMOVE GENERATOR BRACKET


    1. A003DJ0E01

      Remove the 2 bolts, then remove the generator bracket.

  16. Click here

    REMOVE GENERATOR ASSEMBLY


    1. A003CGHE01

      Disconnect the generator connector.

    2. Remove the terminal cap.

    3. Remove the nut and disconnect the wire harness from terminal B.

    4. Remove the bolt and generator assembly.