ГЕНЕРАТОР СНЯТИЕ


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 4 AIR HOSE

    A003CZ9

    1. Slide the 2 clips and disconnect the oil return hose.

    2. Loosen the 2 hose clamps and remove the No. 4 air hose.

  4. REMOVE INTERCOOLER AIR TUBE


    1. A003GD5

      Remove the 2 bolts and air tube support bracket.

    2. A003FRJ

      Disconnect the connector from the intake air temperature sensor.

    3. Loosen the hose clamp and remove the intercooler air tube from the diesel throttle body assembly.

  5. REMOVE FAN AND GENERATOR V BELT


    1. A003GF4E01
      Обозначения на рисунке
      *a Технологическое отверстие
      *b Штырь

      Поворачивая натяжитель поликлинового ремня по часовой стрелке, совместите технологические отверстия натяжителя поликлинового ремня, а затем вставьте в технологические отверстия стержень диаметром 5,0 мм (0,197 дюйма), чтобы закрепить натяжитель поликлинового ремня на месте.

    2. Снимите поликлиновой ремень вентилятора и генератора.

  6. REMOVE GENERATOR ASSEMBLY


    1. A003CFE

      Detach the clamp and disconnect the wire harness.

    2. Disconnect the connector from the generator assembly.

    3. Remove the terminal cap.

    4. Remove the nut and disconnect the wire harness from terminal B.

    5. A003EZW

      Remove the 2 bolts and generator assembly.