СТАРТЕР РАЗБОРКА


  1. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    1. A003B3R

      Remove the nut and disconnect the lead wire from terminal C.

    2. A003HWZ

      Remove the 2 nuts from the repair service starter kit while holding the magnet starter switch assembly.

    3. A003BCT

      Pull the magnet starter switch assembly and, while lifting the front part of the magnet starter switch assembly, release the plunger hook from the starter pinion drive lever and remove the magnet starter switch assembly.

  2. REMOVE STARTER YOKE ASSEMBLY


    1. A003CP7

      Using a T25 "TORX" socket wrench, remove the 2 bolts.

    2. A003AYE

      Remove the starter yoke assembly and starter commutator end frame assembly from the repair service starter kit.

    3. A003I50

      Remove the starter armature plate from the starter yoke assembly or repair service starter kit.

    4. A003HU0

      Remove the 3 planetary gears from the repair service starter kit.

    5. A003GG8

      Remove the rubber seal from the repair service starter kit.

  3. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    1. A003DW6

      Remove the 2 screws from the starter commutator end frame assembly.

    2. A003HHI

      Remove the starter commutator end frame assembly from the starter yoke assembly.

      Note

      While holding down the lead wire, remove the starter commutator end frame assembly.

    3. A003BYP

      Remove the starter brush holder assembly from the starter armature assembly.

  4. REMOVE STARTER ARMATURE ASSEMBLY


    1. A003EQP

      Remove the starter armature assembly from the starter yoke assembly.