Click here

ВЫПУСКНАЯ ТРУБА СНЯТИЕ

Click here
Click here Click here
  1. Click here

    REMOVE TAILPIPE ASSEMBLY


    1. Remove the 2 bolts and disconnect the tailpipe assembly from the exhaust pipe support.

    2. Remove the gasket.

  2. Click here

    REMOVE EXHAUST PIPE DAMPER


    1. A003CCT

      Remove the 2 bolts and exhaust pipe damper from the tailpipe assembly.

  3. Click here

    REMOVE CENTER EXHAUST PIPE ASSEMBLY


    1. Remove the 2 bolts and 2 nuts then disconnect the center exhaust pipe assembly from the 2 exhaust pipe supports.

    2. Remove the gasket.

  4. Click here

    REMOVE NO. 1 FRONT FLOOR HEAT INSULATOR


    1. A003F1H

      Remove the 3 bolts and No. 1 front floor heat insulator.

  5. Click here

    REMOVE NITROGEN OXIDES SENSOR

    CAUTION:

    To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


    1. A003ED6

      Remove the 2 nuts, detach the connector and clamp, and then disconnect the harness and controller portion.

    2. A003B3ZE01

      Using SST, remove the nitrogen oxides sensor.

      09224-00012
  6. Click here

    REMOVE NO. 4 EXHAUST GAS TEMPERATURE SENSOR


    1. A003GIP

      Disconnect the connector from the No. 4 exhaust gas temperature sensor.

    2. A003E8U

      Using a 14 mm union nut wrench, remove the No. 4 exhaust gas temperature sensor from the front exhaust pipe assembly.

  7. Click here

    REMOVE UREA INJECTOR SET

    (Click here)

  8. Click here

    REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. Remove the 2 bolts, 2 compression springs and disconnect the front exhaust pipe assembly from the 2 exhaust pipe supports .

    2. Remove the gasket.