Click here

АДСОРБЕР УСТАНОВКА

Click here
Click here
  1. Click here

    INSTALL CHARCOAL CANISTER ASSEMBLY


    1. Install the charcoal canister assembly to the bracket.

    2. Connect the 2 purge line hoses, and slide the 2 clamps to secure the hoses.

  2. Click here

    INSTALL BATTERY CARRIER


    1. Install the battery carrier with the 3 bolts.

      8.0 N*m 82 kgf*cm 71 in.*lbf

    2. Attach the wire harness clamp to the battery carrier.

    3. Connect the battery thermometer sensor connector.

  3. Click here

    INSTALL BATTERY

  4. Click here

    INSTALL BATTERY CLAMP SUB-ASSEMBLY


    1. Temporarily install the bolt and tighten the nut.

    2. Adjust the battery clamp sub-assembly position.

    3. Tighten the bolt and nut.

      5.4 N*m 55 kgf*cm 48 in.*lbf
  5. Click here

    CONNECT CABLE TO POSITIVE BATTERY TERMINAL


    1. Connect the positive (+) battery terminal to the battery and tighten the nut.

      5.4 N*m 55 kgf*cm 48 in.*lbf
  6. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


    1. Connect the negative (-) battery terminal to the battery and tighten the nut.

      5.4 N*m 55 kgf*cm 48 in.*lbf
      Note:

      When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).

  7. Click here

    PERFORM INITIALIZATION

    (Click here)