Click here

КЛАПАН ПЕРЕКЛЮЧЕНИЯ ПОДАЧИ ВОЗДУХА СНЯТИЕ

Click here
Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE FRONT SEAT ASSEMBLY RH

    (Click here)

  4. Click here

    REMOVE FRONT DOOR SCUFF PLATE RH

  5. Click here

    REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY


    1. Заверните коврик, выверните 5 болтов и снимите дополнительную крышку технологического отверстия двигателя.

  6. Click here

    REMOVE BATTERY SERVICE HOLE COVER


    1. Roll up the floor carpet.

    2. Remove the battery service hole cover.

  7. Click here

    REMOVE AIR PUMP INLET PIPE


    1. A003HMJE02

      Slide the clamp and disconnect the No. 6 air hose.

      Table 1. Text in Illustration
      *1 No. 5 Air Hose
      *2 Air Pump Inlet Pipe
      *3 No. 6 Air Hose

    2. Slide the clamp and disconnect the No. 5 air hose.

    3. Remove the 2 bolts and air pump inlet pipe.

  8. Click here

    REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    1. A003H51

      Remove the 4 bolts and No. 1 exhaust manifold heat insulator.

  9. Click here

    REMOVE NO. 4 INTAKE PIPE


    1. A003D55E02

      Remove the 4 nuts and No. 4 intake pipe.

    2. Remove the 2 gaskets.

  10. Click here

    REMOVE AIR SWITCHING VALVE ASSEMBLY


    1. A003B3VE02

      Disconnect the air switching valve connector.

    2. Remove the 2 nuts and air switching valve assembly.