ДАТЧИК СОСТАВА ТОПЛИВОВОЗДУШНОЙ СМЕСИ УСТАНОВКА

INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

1. 

   Using SST, install the air fuel ratio sensor to the front exhaust pipe assembly.

   09224-00010

   without SST
   44 N*m	449 kgf*cm	32 ft.*lbf
   with SST
   40 N*m	408 kgf*cm	30 ft.*lbf

   Table 1. Text in Illustration

   *a	Fulcrum Length

   Tip:
   

   • Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).

   • Make sure SST and the wrench are connected in a straight line.

2. Connect the air fuel ratio sensor connector.