ДАТЧИК ТЕМПЕРАТУРЫ ОТРАБОТАВШИХ ГАЗОВ (задний) УСТАНОВКА


  1. REMOVE NO. 4 EXHAUST GAS TEMPERATURE SENSOR


    1. A003COCE06
      Text in Illustration
      *a Torque Wrench Fulcrum Length

      Using a 14 mm union nut wrench, install the No. 4 exhaust gas temperature sensor to the front exhaust pipe assembly.

      Torque
      Specified tightening torque
      30 N*m {306 kgf*cm, 22 ft.*lbf}

      Note

      If the No. 4 exhaust gas temperature sensor is dropped, replace it with a new.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench Click here.

      • When using a union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 26 N*m (268 kgf*cm, 19 ft.*lbf)

    2. Connect the connector to the No. 4 exhaust gas temperature sensor.