ФОРСУНКА ВПРЫСКА МОЧЕВИНЫ СНЯТИЕ


  1. REMOVE NO. 2 ENGINE UNDER COVER


    1. Remove the 6 bolts and No. 2 engine under cover from the body.

  2. DISCONNECT UREA TUBE WITH HEATER ASSEMBLY

    Note


    • Check for dirt or mud on the urea injector set and around the urea tube connector before disconnection. Clean if necessary.

    • In order to prevent the urea injector set interior portion from drying, perform installation and removal work as quickly as possible.


    1. Disconnect the urea tube with heater assembly from the urea injector set.


      1. A003AL1

        Detach the lock claw by lifting up the cover.

        Text in Illustration
        A003DCD Lift Up
      2. A003ASL

        Pinch the retainer of the urea tube connector, and then pull the urea tube connector off of the urea tube with heater assembly.

        Text in Illustration
        A003DCD Pinch
        A003GWQ Pull

        Note


        • If there is any solidified urea solution (white solids) on the connection area, clean the solids off with a damp cloth, etc., before disconnecting the urea tube connector.

        • Be sure to disconnect the urea tube connector by hand.

        • Check for foreign matter in the urea injector set and around the urea tube connector. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the urea injector set and urea tube connector.

        • Put the urea injector set and urea tube connector ends in plastic bags to prevent damage and foreign matter contamination.

  3. REMOVE UREA INJECTOR SET


    1. A003EWW

      Disconnect the connector from the urea injector set.

    2. A003ATP

      Remove the 2 nuts and urea injector set and gasket from the front exhaust pipe assembly.