ТОПЛИВНАЯ ФОРСУНКА СНЯТИЕ

DISCHARGE FUEL SYSTEM PRESSURE

Click here
PRECAUTION

Note

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE THROTTLE BODY ASSEMBLY

Click here
DISCONNECT NO. 1 FUEL HOSE
1. Disconnect the No. 1 fuel hose from the fuel pressure pulsation damper assembly Click here.
REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
Note

Be careful not to drop the fuel injector assemblies when removing the fuel delivery pipe sub-assembly.
1. Disconnect the vacuum hose from the fuel pressure regulator assembly.
2. Slide the clamp and disconnect the No. 2 fuel hose from the fuel pressure regulator assembly.
3. Disconnect the 4 fuel injector connectors.
4. Remove the 2 bolts, fuel pressure pulsation damper assembly and O-ring.
5. Remove the 2 bolts and fuel delivery pipe sub-assembly together with the 4 fuel injector assemblies.
  
  Note
  
  Be careful not to drop the fuel injector assemblies when removing the fuel delivery pipe sub-assembly.
6. Remove the 2 No. 1 delivery pipe spacers from the cylinder head sub-assembly.
7. Remove the 4 injector vibration insulators.
8. Text in Illustration
  
  *a Protective Tape
  
  Using a screwdriver, pry out the 4 injector spacers and 4 O-rings from the cylinder head sub-assembly.
  
  Tech Tips
  
  Tape the screwdriver tip before use.
REMOVE FUEL INJECTOR ASSEMBLY
1. Pull out the 4 fuel injector assemblies from the fuel delivery pipe sub-assembly.
  
  Text in Illustration
  
  Pull Out
2. Remove the O-rings from the fuel injector assemblies.