Click here

ЗАДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА УСТАНОВКА

Click here
Click here Click here
  1. Click here

    INSTALL ENGINE REAR OIL SEAL


    1. A003DQEE02

      Apply MP grease to a new oil seal lip.

      Note:

      Keep the lip free from foreign matter.

    2. Using SST, tap in the oil seal until its surface is flush with the engine rear oil seal retainer edge.

      09223-15030
      09950-70010 09951-07100
      Note:

      Wipe off extra grease on the crankshaft.

  2. Click here

    INSTALL FLYWHEEL HOUSING DUST SEAL


    1. Install the flywheel housing dust seal.

  3. Click here

    INSTALL REAR END PLATE


    1. Install the 2 bolts and rear end plate.

      27 N*m 275 kgf*cm 19 ft.*lbf
  4. Click here

    INSTALL FLYWHEEL SUB-ASSEMBLY


    1. A003DJJE01

      Using SST, hold the crankshaft.

      09213-54015 91651-60855
      09330-00021

    2. Clean the bolts and bolt holes.

    3. Apply adhesive to 2 or 3 threads of the bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    4. Install the flywheel on the crankshaft.

    5. A003I2FE01

      Install and uniformly tighten the 8 bolts in several steps, in the sequence shown.

      123 N*m 1,250 kgf*cm 90 ft.*lbf
      Note:

      Do not start the engine within an hour after installing.

  5. Click here

    INSTALL CLUTCH DISC ASSEMBLY


    1. A003BBRE01

      Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.

      09301-00110
      Note:

      Take care not to insert the clutch disc assembly in the wrong direction.

  6. Click here

    INSTALL CLUTCH COVER ASSEMBLY


    1. A003H0AE02

      Align the matchmarks on the clutch cover assembly with the one on the flywheel sub-assembly.

    2. Following the procedures shown in the illustration, tighten the 6 bolts starting from the bolt located near the knock pin on the top.

      09301-00110
      19 N*m 195 kgf*cm 14 ft.*lbf
      Tip:

      • Evenly tighten the bolts by following the order shown in the illustration.

      • Tighten the bolts after checking that the disc is in the center by lightly moving the SST up and down, left and right.

  7. Click here

    INSTALL MANUAL TRANSMISSION ASSEMBLY

    (Click here)