ЗАДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА СНЯТИЕ


  1. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)

    Click here

  2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

    Click here

  3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)


    1. A003FS3E01

      Put matchmarks on the clutch cover assembly and the flywheel sub-assembly.

    2. Loosen each set bolt one turn at a time until spring tension is released.

    3. Remove the set bolts, and pull off the clutch cover assembly.

      Note

      Do not drop the clutch disc assembly.

  4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

    Note

    Keep the lining part of the clutch disc assembly, the pressure plate and surface of the flywheel sub-assembly away from oil and foreign matter.

  5. REMOVE FLYWHEEL SUB-ASSEMBLY


    1. A003FGOE01

      С помощью SST зафиксируйте коленчатый вал.

      SST
      09213-58013
      09330-00021
    2. A003AKXE01

      Для моделей с механической трансмиссией.


      1. Выверните 8 болтов и снимите маховик.

    3. Для моделей с автоматической трансмиссией.


      1. Выверните 8 болтов, снимите заднюю распорную втулку ведущего диска, ведущий диск и маховик.

  6. REMOVE REAR END PLATE


    1. Выверните болт и снимите заднюю крышку.

  7. REMOVE ENGINE REAR OIL SEAL RETAINER


    1. A003EAL

      Remove the 7 bolts and engine rear oil seal retainer.

  8. REMOVE ENGINE REAR OIL SEAL


    1. A003H37E01

      Remove the oil seal with a slotted screwdriver in the manner shown in the illustration.

      Tech Tips

      Put a protection material around its sharp end of the screwdriver to protect the oil seal retainer.

    2. Remove oil seal packing (FIPG) from the engine rear oil seal retainer.