Click here

ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА СНЯТИЕ

Click here
Click here
  1. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. Click here

    REMOVE FRONT SEAT ASSEMBLY RH

    (Click here)

  3. Click here

    REMOVE FRONT DOOR SCUFF PLATE RH

  4. Click here

    REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY


    1. Заверните коврик, выверните 5 болтов и снимите дополнительную крышку технологического отверстия двигателя.

  5. Click here

    REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE


    1. A003EFGE01

      Remove the bolt and engine oil level dipstick guide.

  6. Click here

    REMOVE FAN AND GENERATOR V BELT


    1. A003GP7E01

      С помощью шестигранника, указанного на рисунке стрелкой, сдвиньте шкив натяжителя вниз, уменьшив тем самым натяжение поликлинового ремня вентилятора и генератора. Затем снимите поликлиновой ремень вентилятора и генератора.

      Note:

      При снятии поликлинового ремня вентилятора и генератора не используйте болт опорного ролика.

      Tip:

      После снятия поликлинового ремня вентилятора и генератора переместите натяжитель вверх, насколько это возможно.

  7. Click here

    DISCONNECT COOLER COMPRESSOR ASSEMBLY


    1. Disconnect the compressor and magnetic clutch connector.

    2. A003DDVE02

      Remove the 4 bolts and disconnect the compressor and magnetic clutch from the engine.

      Tip:

      Disconnect the compressor and magnetic clutch with the No. 1 cooler refrigerant suction hose and No. 1 cooler refrigerant discharge hose stuck by suspended from the rope.

    3. Support the compressor and magnetic clutch securely.

  8. Click here

    REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET


    1. A003EEI

      Remove the 5 bolts and No. 1 compressor mounting bracket.

  9. Click here

    REMOVE CRANKSHAFT POSITION SENSOR


    1. A003FHA

      Disconnect the crankshaft position sensor connector and detach the 2 wire harness clamps.

    2. A003FG7

      Remove the bolt and crankshaft position sensor.