ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА СНЯТИЕ


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT SEAT ASSEMBLY RH

    Click here

  3. REMOVE FRONT DOOR SCUFF PLATE RH

  4. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY


    1. Заверните коврик, выверните 5 болтов и снимите дополнительную крышку технологического отверстия двигателя.

  5. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE


    1. A003EFGE01

      Remove the bolt and engine oil level dipstick guide.

  6. REMOVE FAN AND GENERATOR V BELT


    1. A003GP7E01

      С помощью шестигранника, указанного на рисунке стрелкой, сдвиньте шкив натяжителя вниз, уменьшив тем самым натяжение поликлинового ремня вентилятора и генератора. Затем снимите поликлиновой ремень вентилятора и генератора.

      Note

      При снятии поликлинового ремня вентилятора и генератора не используйте болт опорного ролика.

      Tech Tips

      После снятия поликлинового ремня вентилятора и генератора переместите натяжитель вверх, насколько это возможно.

  7. DISCONNECT COOLER COMPRESSOR ASSEMBLY


    1. Disconnect the compressor and magnetic clutch connector.

    2. A003DDVE02

      Remove the 4 bolts and disconnect the compressor and magnetic clutch from the engine.

      Tech Tips

      Disconnect the compressor and magnetic clutch with the No. 1 cooler refrigerant suction hose and No. 1 cooler refrigerant discharge hose stuck by suspended from the rope.

    3. Support the compressor and magnetic clutch securely.

  8. REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET


    1. A003EEI

      Remove the 5 bolts and No. 1 compressor mounting bracket.

  9. REMOVE CRANKSHAFT POSITION SENSOR


    1. A003FHA

      Disconnect the crankshaft position sensor connector and detach the 2 wire harness clamps.

    2. A003FG7

      Remove the bolt and crankshaft position sensor.