Click here

КОРПУС ДРОССЕЛЬНОЙ ЗАСЛОНКИ СНЯТИЕ

Click here
Click here
  1. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. Click here

    DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator reservoir cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

    Tip:

    Collect the engine coolant in a container and dispose of it according to the local regulations.


    1. A003BS1E01

      Loosen the radiator drain cock plug and drain the engine coolant.

      Table 1. Text in Illustration
      *1 Radiator Reservoir Cap Sub-assembly *2 Radiator Reservoir Assembly
      *3 Radiator Drain Cock Plug *4 Cylinder Block Water Drain Cock Plug
      *5 2-Way - -

    2. Remove the radiator reservoir cap sub-assembly.

    3. Loosen the cylinder block water drain cock plug and drain the engine coolant from the engine.

  3. Click here

    REMOVE FRONT SEAT ASSEMBLY RH

    (Click here)

  4. Click here

    REMOVE FRONT DOOR SCUFF PLATE RH

  5. Click here

    REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY


    1. Заверните коврик, выверните 5 болтов и снимите дополнительную крышку технологического отверстия двигателя.

  6. Click here

    REMOVE INTAKE AIR CONNECTOR


    1. A003DHQ

      Slide the clamp and disconnect the No. 2 PCV hose from the cylinder head cover sub-assembly.

    2. Disconnect the vacuum hose from the intake air connector.

    3. Loosen the 2 hose clamps.

    4. Remove the 2 bolts and intake air connector.

  7. Click here

    REMOVE THROTTLE BODY ASSEMBLY


    1. A003G8W

      Disconnect the throttle motor connector.

    2. Slide the clamp and disconnect the water by-pass hose from the throttle body.

    3. Slide the clamp and disconnect the No. 2 water by-pass hose from the throttle body.

    4. Remove the 4 bolts and throttle body assembly.

    5. A003DR5

      Remove the gasket from the intake manifold.