ECM СНЯТИЕ

REMOVE BATTERY SERVICE HOLE COVER

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

REMOVE FRONT DOOR SCUFF PLATE RH

REMOVE FRONT SEAT ASSEMBLY RH

• for Hi-back Seat Type (Click here)

• for Low-back Seat Type (Click here)

• for Split Bench Seat Type (Click here)

REMOVE ECM

1. Fold back the floor carpet.

2. 

   Remove the 3 bolts and disconnect the ECM.

3. 

   Detach the 2 wire harness clamps from the No. 1 ECM bracket and No. 2 ECM bracket.

   Table 1. Text in Illustration

   *a	Push
   *b	Lock

4. Disconnect the 2 ECM connectors and remove the ECM.

   Note:

   After disconnecting a ECM connector, make sure that dirt, water and other foreign matter does not contact the ECM connector.

   
   

   1. Raise the 2 levers while pushing the locks on the 2 levers and disconnect the 2 ECM connectors.

   2. Remove the ECM.

REMOVE NO. 1 ECM BRACKET

1. 

   Remove the 3 screws and No. 1 ECM bracket.

REMOVE NO. 2 ECM BRACKET

1. 

   Remove the 2 screws and No. 2 ECM bracket.