ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА УСТАНОВКА


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. A003ADQ

      Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

    2. A003FZL

      Install the crankshaft position sensor with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Be careful that the O-ring is not cracked or jammed when installing the crankshaft position sensor.

    3. Connect the 3 wire harness clamps.

    4. A003DF5

      Connect the crankshaft position sensor connector to the vacuum pipe No.1.

    5. Connect the crankshaft position sensor connector.

  2. INSTALL VANE PUMP OIL RESERVOIR ASSEMBLY


    1. A003HN0

      Install the vane pump oil reservoir assembly with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  3. INSTALL ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)

    Torque:
    13 Н*м  { 133 кгс*см, 10 фунт-сила-футов }