РЕЛЕ ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ


  1. INSPECT DCU RELAY (DCU)


    1. A003GBGE01

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the DCU relay.

  2. INSPECT EFI MAIN RELAY (EFI MAIN)


    1. A003GV1E04

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the EFI MAIN relay.

  3. INSPECT EFI NO. 2 RELAY (EFI NO. 2)


    1. A003GV1E04

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the EFI NO. 2 relay.

  4. INSPECT EDU RELAY (EDU)


    1. A003GV1E04

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the EDU relay.

  5. INSPECT NOX RELAY (NOX)


    1. A003GV1E04

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the NOX relay.

  6. INSPECT NO. 2 INTEGRATION RELAY

    Note


    • The IG2 relay is built into the No. 2 integration relay.

    • Before performing the relay inspection for the relay of the No. 2 integration relay, inspect the IG2-MAIN fuse.


    1. Inspect the IG2 relay.


      1. A003BJME05
        Text in Illustration
        *a

        Component without harness connected

        (No. 2 Integration Relay)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        12A-1 - 12D-1 Battery voltage not applied to terminals 12D-2 and 12E-4 10 kΩ or higher
        Battery voltage applied to terminals 12D-2 and 12E-4 Below 1 Ω

        If the result is not as specified, replace the No. 2 integration relay.