СИСТЕМА ECD ОСНОВНАЯ ПРОВЕРКА

Tech Tips

When a malfunction cannot be confirmed by the DTC check, troubleshooting should be performed on all circuits that are possible causes of the problem. However, in most cases, performing the basic engine check shown below can help you find the problem quickly and efficiently. Always perform this check first when troubleshooting the engine.


  1. CHECK BATTERY VOLTAGE

    Note

    Perform the battery voltage check with the engine stopped and the ignition switch off.

    Result
    Result Proceed to
    11 V or higher OK
    Below 11 V NG

    NG

    CHARGE OR REPLACE BATTERY
    OK

  2. CHECK IF ENGINE WILL CRANK


    NG

    PROCEED TO PROBLEM SYMPTOMS TABLE
    OK

  3. CHECK AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


    1. Visually check that the air cleaner filter element sub-assembly is not excessively contaminated with dirt or oil.


      NG

      CLEAN OR REPLACE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
      OK

  4. CHECK FUEL QUALITY


    1. Check that only diesel fuel is being used.

    2. Check that the fuel does not contain any impurities.


      NG

      REPLACE FUEL
      OK

  5. CHECK FUEL FOR AIR


    NG

    BLEED AIR FROM FUEL
    OK

  6. CHECK FUEL PIPES AND HOSES


    1. Check that the fuel pipes and fuel hoses are not blocked, damaged, disconnected or bent.


      NG

      REPAIR OR REPLACE FUEL PIPES OR HOSES
      OK

  7. CHECK FUEL FILTER ELEMENT ASSEMBLY FOR BLOCKAGE


    NG

    REPAIR OR REPLACE FUEL FILTER ELEMENT ASSEMBLY
    OK

  8. CHECK ENGINE OIL


    NG

    ADD OR REPLACE ENGINE OIL
    OK

  9. CHECK ENGINE COOLANT


    NG

    ADD OR REPLACE ENGINE COOLANT
    OK

  10. CHECK IDLING SPEED AND MAXIMUM SPEED


    NG

    REPLACE FUEL SUPPLY PUMP ASSEMBLY
    OK

  11. CHECK DIAGNOSTIC CIRCUIT


    NG

    REPAIR OR REPLACE MALFUNCTIONING CIRCUIT
    OK

  12. CHECK VACUUM PUMP


    NG

    REPAIR OR REPLACE VACUUM PUMP
    OK
    PROCEED TO PROBLEM SYMPTOMS TABLE